Roland MV-8000 - Outputting Digital Audio from R-BUS or Analog Multi-Output

174
Using the MV8-OP1 (Audio I/O Expansion) to connect external devices
Outputting digital audio from R-BUS or analog
multi-output
You can output the audio from the MV-8000's multi output bus via the R-BUS
connector (digital) or the analog multi output (analog).
1.
Connect the MV-8000 with your output destination device as described in
Quick Start “Preparing your equipment and making connections” (p. 4).
2.
Press .
The MIXER (AUDIO TRACK) screen (p. 378) will
appear.
3. Set the Output parameter to MLT1~8 or
M1/2~7/8.
Set the Output parameter of the part whose signal
you want to send to the multi output bus. The signal sent to each bus will be output via
R-BUS and the analog multi output.
To select a different mixer part, press [F1]~[F4]. For details, refer to the MIXER (AUDIO TRACK)
screen (p. 378), MIXER (INSTRUMENT PART) screen (p. 379), MIXER (AUX / FX / AUDIO
PHRASE / INPUT) screen (p. 380).
Value
Destination bus R-BUS
output
channel
Analog multi output
MLT1
Multi output bus 1 1 1
: : : :
MLT6 Multi output bus 6 6 6
MLT7 Multi output bus 7 7 Not output
MLT8 Multi output bus 8 8 Not output
M1/2 Multi output bus 1/2 1 and 2 1 and 2
M3/4 Multi output bus 3/4 3 and 4 3 and 4
M5/6 Multi output bus 5/6 5 and 6 5 and 6
M7/8 Multi output bus 7/8 7 and 8 Not output
The identically-numbered
R-BUS and analog multi
output will output the same
audio.
The audio signal of multi
output bus 7 and 8 cannot be
output via analog multi
output.
ECS05_manual_e.book 174 ページ ２００５年１１月３０日 水曜日 午前１１時１４分