Roland MV-8000 - QUICK ASSIGN (AUDIO PHRASE) Screen

360
SAMPLING
QUICK ASSIGN (AUDIO PHRASE) screen
Here you can assign samples to pads.
To access this screen
• ➜ ➜ (start sampling) ➜
(stop sampling) ➜
Explanation of each area
1. Sample Name
Displays the name of the sample.
2. Sample Channel
Displays the number of channel of the sample
(Mono/Stereo).
3. Wave window
Displays the sampled data (waveform).
4. Pads
Indicates the state of the pads in the current pad
bank.
5. Assign To
Selects the pad to which the sample will be assigned.
Range: 1-1 ~32-16
You can also specify a pad by striking it directly.
F-buttons
Name
Displays the EDIT NAME popup (p. 199), where you
can edit the pad name.
Preview
Auditions the currently-highlighted sample. To hear
auditioning, hold down [F4 (Preview)].
Set
Assigns the sample to the specified pad.
When automatically assigning samples, a
confirmation message will appear if a pad to which
a sample is already assigned would be overwritten.
EXIT
Returns to the SAMPLING / RE-SAMPLING screen
(p. 355) without assigning the sample data to a pad.
Indicate
Status
A partial is assigned to the pad.
Nothing is assigned.
An audio phrase will assign to the
enclosed pad.
ECS05_manual_e.book 360 ページ ２００５年１１月３０日 水曜日 午前１１時１４分