345
MASTERING
PROJECT SYSTEM DISK/USB MASTERING SAMPLING
MASTERING TOOL KIT EDIT screen
Here you can edit all the parameters of the mastering
tool kit.
To access this screen
•
➜➜
(select a file)
➜➜
Explanation of each area (EQ)
Here you can adjust the tonal character.
1.
Mastering Tool Kit
Here you can make settings for the mastering effects.
2.
Effect block
Shows the internal structure (blocks) of the mastering
tool kit. The block you are currently editing is shown
by the cursor. Use [F1 (Block
▲
)] or [F2 (Block
▼
)] to
move between blocks.
3.
Block name (EQ)
Shows the EQ parameters.
4.
Switches
Switches the EQ block on/off.
Range: Off, On
5.
G (Gain)
Specifies the amount of boost/cut for each band
(Low/Low-Mid/Hi-Mid/High).
Range: -12~+12 dB
6.
F (Frequency)
Specifies the center frequency at which each band
(Low/Low-Mid/Hi-Mid/High) will be boosted or
cut.
7.
Q
Specifies the sharpness of the frequency response
curve for each band (Low/Low-Mid/Hi-Mid/High).
8.
Type
Specifies the type of equalizer for the Low band and
High band.
* The Q parameter has no effect for bands whose
Type is set to Shelving.
9.
Input Gain
Adjusts the overall volume before the signal passes
through the equalizer.
Range: -24~+12 dB
10.
Output Gain
Adjusts the overall volume after the signal has passed
through the equalizer.
Range: -24~+12 dB
Parameter
Range
Low
20~2000 Hz
Low-Mid 20~8000 Hz
Hi-Mid 20~8000 Hz
High 1.4~20.0 kHz
Parameter
Value
Shelving
Shelving type*
Peaking Peaking type
ECS05_manual_e.book 345 ページ ２００５年１１月３０日 水曜日 午前１１時１４分
To Next Page
Loading...
