315
PROJECT
PROJECT SYSTEM DISK/USB MASTERING SAMPLING
LOAD PROJECT screen
Here you can load a project, making it the current
project.
To access this screen
•
➜
(move the cursor to the upper row of
icons)
➜
Explanation of each area
1.
Project list
This area lists the saved projects. The project selected
by the cursor is highlighted.
2.
Name
This area shows the names of the saved projects.
3.
Wave Size
Displays the size of project at the cursor in project list.
F-buttons
Execute
Loads the project selected by the cursor. When
loading is completed, the
SEQUENCE screen
(p.
205) will appear.
If the display asks “Save Current?”
Your changes will be lost unless you save the current
project before loading another project.
If you don't save the current project at the “Save
Current?” prompt, there is no way for you to
recover that data (unless you have previously made
a backup of it). Roland accepts no responsibility for
the recovery of lost data, nor for any damages that
may result from such loss.
If the display indicates “Current project is protected.
Can't overwrite it.”
The current project is protected, and cannot be
overwritten (saved). You will either have to turn off
Protect before saving the project, or use
SAVE AS
NEW PROJECT popup
(p. 313) to create and save a
new project.
If the display indicates “Project is too large”
The project you are attempting to load is too large to
load. This can occur if the currently-installed amount
of memory is less than the amount of memory that
was installed when you created the project. In order
to load this project, you will need to install at least as
much memory as was installed when the project was
created.
F-button
Explanation
No
To discard your changes and load
the project.
Yes
To save the current project before
loading the project.
Cancels the loading project
operation.
ECS05_manual_e.book 315 ページ ２００５年１１月３０日 水曜日 午前１１時１４分
To Next Page
Loading...
