Roland MV-8000 - STEP REC (AUDIO) Screen

255
SEQUENCE
Common items in all screens SEQUENCE SONG SETUP INSTRUMENTS AUDIO PHRASES
STEP REC (AUDIO) screen
Here you can use the pads to record onto an audio
track.
To access this screen
•+
In order to open this popup, you must specify an
audio track as the current track.
Explanation of each area
1. Step Time
Specifies the note value of the notes you will input.
Range: (30), (40), (60), (80), (120),
(160), (240), (320), (480) ,
(640), (960), (1920), (3840), Meas
In the STEP REC screen you can change the step
time by pressing [SHIFT] + ([ (1)] ~ [ (9)])
(numeric keys).
2. Duration
Specifies the actual length of the note, as a percentage
of the note value you specified for Step Time.
Range: 1~ 100 %
3. Velocity
Specifies the strength of the note.
Range: Real , 1~127
4. No. (track number and icon)
Shows the number of the tracks recorded in the
sequencer. The MV-8000 lets you create up to 128
MIDI sequence tracks and 8 audio tracks. The icon at
the right of the track number shows the type of track.
The line of the track number selected by the cursor
is highlighted. This track is called the “current
track.”
5. Track Name
Shows the name assigned to each track.
6. Play List
The boxes show the existence of sequence data
recorded in each track.
F-buttons
Back Step
Reverts the preceding input.
Tie
Connects (extends) the event at the current time to
the next step.
Rest
Inputs a rest (silence).
During step recording, you can press [REC] to make
the REC indicator (red) blink. In this state, pressing
the pads will not record anything. This is a
convenient way for you to check the sound
produced by each pad.
Icon
Explanation
MIDI track
Audio track
ECS05_manual_e.book 255 ページ ２００５年１１月３０日 水曜日 午前１１時１４分