Roland MV-8000 - COPY&PASTE Popup

226
SEQUENCE
COPY&PASTE popup
This copies the data of the “In time -- Out time”
region to the specified location.
To access this screen
• ➜
(
select a track as the current track
)
➜ or ➜➜ ( choose Copy&Paste )
➜
The parameters in the COPY&PASTE popup will
differ according to whether you access it from
PIANO ROLL EDIT or from SEQUENCE EDIT. In
this page we describe all the parameters that might
appear; ignore the ones that don't apply.
Explanation of each area
1. To
Specifies the copy-destination time.
Range: 0001-01-000~9999-**-***
** will depend on the time signature you set.
2. To Track
Specifies the copy-destination track number.
• To Track appears only if you are using SEQUENCE
EDIT.
• If you've selected two or more tracks, you won't be
able to select the To Track value. (The display will
indicate “Multi tracks selected.”)
• Only the same type of track can be selected as a
value.
3. Times
Specifies the number of times the copy will be
repeated.
Range: 1 ~99
4. Mode
Selects the way in which any data existing at the
copy-destination will be handled.
5. Transpose
Specifies the amount of transposition in semitone
steps. Specify a positive (+) value to raise the pitch, or
a negative (-) value to lower the pitch. A setting of 0
produces no change.
Range: -127~127
• Transpose appears only if you are using PIANO
ROLL EDIT.
• If executing this transpose operation would cause
the note number to be higher than G9 or lower than
C-1.
F-buttons
Execute
Executes the Copy operation.
You can use the VIEW FILTER popup (p. 245) to
select the events that will be copied.
Value
Explanation
Merge
The data will be combined with the data
that exists at the copy-destination.
Replace
The data will replace (overwrite) the data
that exists at the copy-destination.
ECS05_manual_e.book 226 ページ ２００５年１１月３０日 水曜日 午前１１時１４分