327
SYSTEM
PROJECT SYSTEM DISK/USB MASTERING SAMPLING
DIMM DIAGNOSIS popup
This checks the memory module installed in the
MV-8000.
To access this screen
•
➜
(move the cursor to the upper row of
icons)
➜➜
A confirmation message “Save current project
before?” will appear. Your changes will be lost unless
you save the current project before starting DIMM
DIAGNOSIS.
If you don't save the current project at the “Save
Current?” prompt, there is no way for you to
recover that data (unless you have previously made
a backup of it). Roland accepts no responsibility for
the recovery of lost data, nor for any damages that
may result from such loss.
Now Checking...
The memory module is being checked. Please wait
until checking is completed.
Result
Indicates the result of checking the memory module.
If the result of the test is NG, the installed DIMM is
faulty. Since data cannot be written or read from
this DIMM, it is possible that a malfunction will
occur in the MV-8000's operation. Please replace the
DIMM (p. 186).
F-buttons
Close
Closes the MEMORY DIAGNOSIS popup.
F-button
Explanation
No
To execute DIMM DIAGNOSIS
without saving the current project.
Yes
To save before executing DIMM
DIAGNOSIS
To cancel without executing DIMM
DIAGNOSIS
Display Explanation
OK
The DIMM is OK.
NG The DIMM is faulty.
ECS05_manual_e.book 327 ページ ２００５年１１月３０日 水曜日 午前１１時１４分
To Next Page
Loading...
