Roland MV-8000 - Front Panel

37
Parts of the MV-8000 and what they do
Parts of the MV-8000 and what they doMain FeaturesContents Sampling Editing a sampled sound
Front panel
1. Disk access indicator
This indicator will light when the disk is being read or written.
2.
Floppy disk slot
The MV-8000 can use 3.5 inch 2HD/2DD floppy disks. Insert the disk horizontally and
push it all the way in until it clicks into position.
3.
Floppy disk eject button
To eject the floppy disk, press this button all the way in.
4.
CD-R/RW drive tray
The tray will open when you press the CD-R/RW disc eject button. This drive can
handle CD-ROMs and music CDs, and can also write data to CD-R discs or CD-RW
discs.
5. Emergency disc eject hole
This is an emergency eject switch for the CD-R/RW disc. If the power has been turned
off (e.g., due to a power failure), the tray will not open when you press the CD-R/RW
disc eject button. In this case, you can eject the tray by pushing a straightened paper
clip into this hole.
6.
CD-R/RW disc eject button
Press this button to open the CD-R/RW disc tray.
Never remove the disk
while the disk access
indicator is lit. Doing so
will damage the data
and/or the disk.
Never use the emergency
disc eject hole to eject the
disc while the MV-8000 is
operating. Doing so will
damage the disc and/or the
drive, and may make the
disc jump out of the tray.
If the MV-8000's internal
system is accessing the
CD-R/RW drive, pressing this
button may not eject the CD
tray. This is a safety feature,
not a malfunction.
ECS05_manual_e.book 37 ページ ２００５年１１月３０日 水曜日 午前１１時１４分