Roland MV-8000 - SYSTEM INFORMATION Screen

326
SYSTEM
SYSTEM INFORMATION screen
Here you can check the state of the MV-8000's system.
To access this screen
• ➜ (move the cursor to the upper row of
icons) ➜
Explanation of each area
1. Version
Indicates the MV-8000's software version.
1. DIMM (Memory module) Size
Indicates the amount of memory installed in the
MV-8000.
• When shipped from the factory, a 128 MB DIMM is
installed.
• The DIMM holds wave data and event data.
2. Option
Shows the option boards that are installed in the
MV-8000.
3. Wave Memory
Indicates the amount of wave data stored in the
DIMM, both numerically and as a graph.
4. Sequence Memory
Indicates the amount of sequence data currently in
memory, both numerically and as a graph.
F-buttons
DIMM Diag (Memory Diagnosis)
Diagnoses the installed memory module. The DIMM
DIAGNOSIS popup (p. 327) will appear.
Initialize
Restores all the MV-8000's system parameters to their
factory-set state. A confirmation message “Initialize
all system parameters, OK?” will appear.
Display
Explanation
Audio I/O Expansion
MV8-OP1
VGA monitor/mouse connection kit MV8-VGA
Value
Explanation
Not Installed
This option is not installed.
Installed This option is installed.
used unused
Free capacity
F-button
Explanation
No
To cancel without initializing.
Yes
To initialize the parameters. When
you execute Initialize, all system
parameters will be initialized to
their factory-set state.
To cancel without initializing.
Free capacity
used unused
ECS05_manual_e.book 326 ページ ２００５年１１月３０日 水曜日 午前１１時１４分