213
SEQUENCE
Common items in all screens SEQUENCE SONG SETUP INSTRUMENTS AUDIO PHRASES
RECORDING FILTER popup
Here you can restrict the data that will be recorded
during MIDI sequence recording.
To access this screen
•
➜➜
•
➜➜
In order to open this popup, you must specify a
MIDI track as the current track.
Explanation of each area
1.
Filter
Messages with the
✔
mark will be recorded. If you
remove the
✔
mark, those messages will not be
recorded on the sequencer.
F-buttons
All On
Specifies all messages will be recorded.
All Off
Specifies all messages will not be recorded.
On/Off
Specifies whether the message at the cursor will be
recorded.
Close
Closes the RECORDING FILTER popup.
Parameter
Explanation
Note
Note messages. Data that plays
notes.
Poly
Aftertouch
Polyphonic aftertouch. Data that ap-
plies aftertouch independently to an
individual key.
Control
Change
Control changes. Data that applies
various effects (e.g., modulation) ac-
cording to the control number.
Program
Change
Program changes. Data that selects
sounds (patches).
Channel
Aftertouch
Channel aftertouch. Data that ap-
plies aftertouch to an entire channel.
Pitch Bend
Pitch bend. Data that changes the
pitch.
Tune
Request
This MIDI message causes an analog
synthesizer to tune itself.
Mode
Message
MIDI Mode Message that changes
the mode
System
Exclusive
System exclusive messages. MIDI
messages specific to the MV-8000.
ECS05_manual_e.book 213 ページ ２００５年１１月３０日 水曜日 午前１１時１４分
To Next Page
Loading...
