245
SEQUENCE
Common items in all screens SEQUENCE SONG SETUP INSTRUMENTS AUDIO PHRASES
VIEW FILTER popup
Here you can select the MIDI events that you want to
view or edit in the SEQUENCE, EVENT LIST EDIT,
and SEQUENCE EDIT screens.
To access this screen
•
➜➜
(
choose View Filter
)
➜
•
➜➜➜
(
choose View Filter
)
➜
•
➜➜➜
(
choose View Filter
)
➜
Explanation of each area
1.
Filter
MIDI data with a
✔
mark will be displayed. Your
editing will affect only the displayed events. If you
remove the
✔
mark, those events will not be
displayed or edited.
2.
Ctrl Change (Control change)
Of the control change messages, you can limit the
range of control change numbers that will be
displayed.
3.
Ctrl Change Range (Control change range)
This parameter lets you limit the control change
values that will be received. This parameter works in
conjunction with the Ctrl Change parameter.
Value (lower limit): [0]~119
Value (upper limit): 0~[119]
The Ctrl Change parameter and Ctrl Change Range
parameter are valid if there is a
✔
mark for the Filter
parameter Ctrl Change.
F-buttons
All On
Turns the
✔
mark on for all parameters.
All Off
Turns the
✔
mark off for all parameters.
On/Off
Turns the
✔
mark on/off for an individual
parameter.
Parameter
Explanation
Note
Note messages. Data that plays notes.
Poly
Aftertouch
Polyphonic aftertouch. Data that
applies aftertouch independently to an
individual key.
Control
Change
Control changes. Data that applies vari-
ous effects (e.g., modulation)
according to the control number.
Program
Change
Program changes. Data that selects
sounds (patches).
Channel
Aftertouch
Channel aftertouch. Data that
applies aftertouch to an entire
channel.
Pitch
Bend
Pitch bend. Data that changes the pitch.
Tune
Request
This MIDI message causes an analog
synthesizer to tune itself.
Mode
Message
Mode Messages are messages that switch
the MIDI channel mode.
System
Exclusive
System exclusive messages. MIDI mes-
sages specific to the MV-8000.
Audio
Phrase
Audio Phrase events. Data that plays
sounds. Displays on the
SEQUENCE screen and SQUENCE EDIT
screen only.
Value
Explanation
All
Accept all control change numbers.
Except
Accept all control changes except for the
range specified by Range.
Only
Accept only the control changes in the speci-
fied Range.
ECS05_manual_e.book 245 ページ ２００５年１１月３０日 水曜日 午前１１時１４分
To Next Page
Loading...
