Roland MV-8000 - Page 346

346
MASTERING
Explanation of each area (B-Cut)
Here you can remove unwanted low-frequency
components such as pop noise.
1. Block name (B-Cut)
Displays the bass-cut filter parameters.
2. Switch
Switches the bass-cut filter block on/off.
If you press [F5 (Sw On/Off)], turn effect block
switch on/off.
Range: Off, On
3. Frequency
Specifies the frequency below which unwanted
low-frequency components will be cut.
Range: Thru, 20~2000 Hz
Explanation of each area
(Enhancer)
This adds sparkle to the sound.
1. Block name (Enhancer)
Displays the enhancer parameters.
2. Switch
Switches the enhancer block on/off.
If you press [F5 (Sw On/Off)], turn effect block
switch on/off.
Range: Off, On
3. Sensitivity
Specifies degree of the enhancer effect desired.
Range: 0~100
4. Frequency
Specifies the frequency at which the enhancer begins
to apply.
Range: 1.00~10.0 kHz
5. Mix Level
Adjusts the volume of the enhancer sound.
ECS05_manual_e.book 346 ページ ２００５年１１月３０日 水曜日 午前１１時１４分