Configuration
Quantum Intelligent EV Charging Pedestal EVQM-V01-R6 Installation and Operation Manual
Page 25 of 52 December 2023
Configure Load Balancing
Configuration of the load balancing system is performed using the Smart Application as
part of the online configuration process.
The main fuse or circuit breaker in the property’s consumer unit should be labelled to state
the maximum load. The load balancing system must be set to the same figure (or lower)
than the main fuse or circuit breaker.
x Do NOT set load balancing above the maximum point. Load balancing will not initiate
and all power to the property will be lost if the maximum point is reached.
Depending on the option selected by the installer…
x Load balancing in a domestic system can be configured to initiate load balancing for
properties of between 60 Amps and 100 Amps.
x Load balancing in a commercial system can be configured to initiate load balancing
for properties of between 60 Amps and 255 Amps.
Configuration
Overview
Rolec charge points have been tested for use with our preferred partner Monta but can
be managed by any charging application that properly complies with the Open
Chargepoint Protocol (OCPP) 1.6J.
If the Monta service is NOT going to be used, several other service providers are available
within the configuration application. Whilst these providers have been tested and work
with the charge point, you may need assistance from the chosen provider to establish a
working connection to their network.
NOTE: Compliance with OCPP 1.6J does not guarantee compatibility ‘straight out of the
box’. There are many variables within the specification that can influence the features
that are available.
There is also the option to use service providers that are not listed. Again, you may require
assistance from the service provider to complete the configuration and Rolec cannot
guarantee that all features will be available.
IMPORTANT: Charge point management/operation applications such as that provided
by Monta, or any other service provider, are NOT part of the Rolec product and any
agreements, contracts or fees related to their services will be between you and your
chosen provider.
To Next Page
Loading...
Need help?
General