Chargepoint Installation Completion
EVQM-V01-R6 Installation and Operation Manual Quantum Intelligent EV Charging Pedestal
December 2023 Page 44 of 52
Monta Labels
The Monta ID Label located next to individual sockets or tethered cables can be used to
enable charging by guests at your property, regardless of whether the driver is a Monta
user.
If enabled and configured in the owner’s Monta App, the guest simply scans the QR code
on the label to connect to Monta where they can pay for and initiate a charge at their
own cost.
Refer to the Monta App for further details.
Details about using the chargepoint with Monta can be accessed
from: https://monta.com/uk/help-center or by tapping the Me icon
within the Monta App.
Chargepoint Installation Completion
1. Make sure the…
x Chargepoint is secured to the mounting location.
x Chargepoint enclosure is free of debris.
x Cables entering the chargepoint are secure.
2. Make sure the electrical installation is complete:
x Incoming cables are connected to the relevant devices within the enclosure.
x All electrical connection points are secure.
x All required tests have been performed – in accordance with the current
legislation applicable in the geographical region of the installation.
x Make sure the chargepoint has been installed in compliance with the current
Electrical Wiring Regulations (including recommended earthing arrangements).
3. Fit the front panel to the enclosure and secure it with the key.
4. If required, remove any handling marks from the enclosure with a soft, damp cloth.
5. Make sure this manual is given to the Owner/Host before leaving the site.
To Next Page
Loading...
Need help?
General