Configuration
Quantum Intelligent EV Charging Pedestal EVQM-V01-R6 Installation and Operation Manual
Page 29 of 52 December 2023
No Camera or QR Code Reader?
The processes in this manual describe the use of the smartphone camera to scan a QR
code label as this is the easiest way to establish a Bluetooth connection.
If there are problems such as not having a camera, or the code scanner is not
available, it is possible to connect a phone to the charge point using Bluetooth alone.
These steps can be applied during the
configuration processes described in the
following pages when the application wants to
use the phone camera to scan a QR code.
1. Make sure Bluetooth is enabled on the
phone.
2. During the processes below, the EV
Connect application will open or try to
open the camera.
3. Instead of using the camera, tap the
SEARCH FOR DEVICES button.
The Select a nearby device screen will be
displayed.
4. Tap the SEARCH FOR DEVICES button.
The phone will scan for the charge point
Bluetooth signal.
NOTE: If the Show all devices option is turned on,
the Bluetooth search will find ALL devices that are
in range. With the option turned off, it should only
find charge points.
To Next Page
Loading...
Need help?
General