Configuration
Quantum Intelligent EV Charging Pedestal EVQM-V01-R6 Installation and Operation Manual
Page 31 of 52 December 2023
Configuration For Installers
1. Apply electrical power to the charge point
and allow it to start up.
2. The LED indicator on the charge point will flash
BLUE when the chargepoint is ready.
3. Open the Rolec EV Connect application
on the phone.
4. Read the privacy policy and accept the terms
if you are happy to proceed.
5. Tap on the Installer icon.
6. Tap the NEXT button to continue to the Installer
area of the application.
To Next Page
Loading...
Need help?
General