Configuration
EVQM-V01-R6 Installation and Operation Manual Quantum Intelligent EV Charging Pedestal
December 2023 Page 30 of 52
5. All charge points within the range of the
Bluetooth signal will be listed.
If more than one is listed, you will need to
know which charge point you want to
connect to.
x The charge point ID is shown on the
small QR code label attached to the
Configuration Tag or,
x on the QR code label attached to the communications device inside the
enclosure or,
x is shown as the Serial Number (SN) on the charge point product label.
6. Once the charge point is known, tap the
MAC address and ID text to select it and
move onto the password entry screen.
7. Enter the password (PW) exactly a shown
on the QR code label.
8. Tap the Connect button to enter the configurations screen.
To Next Page
Loading...
Need help?
General