Configuration
Quantum Intelligent EV Charging Pedestal EVQM-V01-R6 Installation and Operation Manual
Page 41 of 52 December 2023
Domestic – Use a Charge Point with Monta
1. Check with the installer that they
have configured the charge point
for use with Monta in Rolec’s EV
Connect application. If not, it will
need to be added.
2. Open the Monta application and
tap the Chargers icon shown at the
bottom of the screen.
3. Make sure the Charge points button
is selected at the top of the screen.
4. Tap the Add a charge point button.
5. Follow the on-screen prompts to enter the charge point brand (Rolec) and model
then tap Continue.
6. Follow the on-screen prompts to name the charge point and provide its address
location, then tap Continue.
7. Select whether the charge point can be used in peak hours, and whether to
enable SmartCharge, and Auto SmartCharge.
8. Tap Add charge point.
If this has all been done correctly the screen will show a success message and ask
if you would like to connect the charge point to the Monta service.
9. Select Connect now then, on the next screen, select OCPP.
IMPORTANT: In the next step, when entering the ID number into the Monta application it
MUST be prefixed with Rolec_ (this must include the underscore).
For example, Rolec_DKA12345
x If you will be adding a charge point with more than one socket or cable (for
example, Rolec_DKA12345-1 and then Rolec_DKA12345-2, they are added
separately to the Monta App.
x In the Monta App this equates to pairing Connector 1 and then pairing Connector
2.
x When adding the connections, you must use the Rolec_DKA12345 type number as
the common identifier for the whole charge point, add connector 1 then repeat the
process to add connector 2 for the same Rolec_DKA12345 charge point.
4-Way Quantum: The 4-way Quantum is effectively 2x 2-way chargers within 1 pedestal
and for pairing with Monta, the pedestal must be treated as though it is 2 chargers.
Each of these chargers has a Configuration Tag that shows an ID such as
Rolec_DKA12345. Use one ID to pair Connector 1 and Connector 2 then repeat the
process using the second Configuration Tag ID to pair Connector 1 and Connector 2 for
the ‘second’ charger.
To Next Page
Loading...
Need help?
General