Need help?Do you have a question about the Rosemount 2700 and is the answer not in the manual?
General| Model | 2700 |
|---|---|
| Category | Measuring Instruments |
| Type | Guided Wave Radar Level Transmitter |
| Accuracy | ± 3 mm (0.12 in.) |
| Process Connection | Threaded, Flanged |
| Output | 4-20 mA HART |
| Communication Protocol | HART |
| Mounting | Top-mounted |
| Certifications | ATEX, IECEx, FM, CSA |
| Material | Stainless steel, Hastelloy, or other alloys |
Critical safety warnings related to electrical hazards and installation.
Procedures for physically installing the analyzer, location considerations.
Instructions for mounting the analyzer in a panel cutout.
Instructions for mounting the analyzer using a pipe mounting kit.
Instructions for mounting the analyzer on a wall.
Guidelines for wiring the analyzer, including power and sensor connections.
Specific wiring instructions for pH/ORP and conductivity sensors.
Procedures to put the analyzer and sensor into immediate operation.
Outlines the general steps for adjusting analyzer readings for any sensor.
Describes conductivity calibration adjustments and temperature/pH/ORP adjustments.
Explains single-point, two-point, and auto-buffering pH calibration methods.
Details the one-point calibration procedure for ORP sensors.
Instructions for configuring the analyzer using the menu mode.
How to change conductivity sensor liquid type/units and pH sensor units.
Setting up high/low level alarms, deadband points, and relay contacts.
Setting up analog and digital output ranges, scaling, and levels.
Configuring security levels and codes for access control.
Changing the instrument's address for network communication.
Changing the address assigned to individual sensors.
Lists diagnostic messages, descriptions, and suggested actions.
Provides a guide of common symptoms and suggested actions for troubleshooting.
Troubleshooting steps for Modbus communication connections.
Common issues encountered during analyzer start-up.
Troubleshooting steps when measurements are incorrect after start-up.
Steps to troubleshoot issues with digital output communication.
To Next Page