Operation
70 / 127
Options
With propulsion engine running:
► Press the Quickstartfunction switch.
Priming pump is activated.
Once the priming process is finished the pump pressure governor is
activated.
The pump pressure governor is set to 4 bar (58 psi).
7.8.3 Training mode/competition mode - Variant 1
With the Training mode and competition modefunction several operat-
ing steps are carried out with one push of a button.
The control unit of the portable pump must be activated.
Training mode
► Briefly actuate the Start propulsion engine function switch to activate
the control unit.
Control unit is activated.
► Press the Training mode function switch.
Training mode is preselected.
The status LED flashes red.
►Actuate the Stop propulsion engine function switch to deactivate the
control unit.
Control unit is deactivated.
Display remains activated.
Status LED illuminates red.
►Actuate Start propulsion engine function switch.
The training mode is activated.
The following operating steps are carried out automatically.
• The propulsion engine is started.
• Priming pump is activated.
• If priming procedure is completed the speed is increased.
► Adjust the output pump pressure via the Governor function switch.
Refer to chapter "Adjust water pump pressure".
Or
► Adjust the output pump pressure via the automatic pump pressure
governor.
Refer to chapter "Pump pressure regulator".
Competition mode
► Briefly actuate the Start propulsion engine function switch to activate
the control unit.
Control unit is activated.
To Next Page
Loading...
