Operation
72 / 127
Options
► Adjust the output pump pressure via the automatic pump pressure
governor.
Refer to chapter "Pump pressure regulator".
Competition mode
►Actuate Start propulsion engine function switch to start the propulsion
engine.
Propulsion engine is started.
► Press the Competition mode function switch.
Competition mode is preselected.
The status LED flashes red.
►Actuate Start propulsion engine function switch.
Competition mode is activated.
The following operating steps are carried out automatically and in the
quickest possible time.
• Priming pump is activated.
• If priming procedure is completed the speed is increased.
► Adjust the output pump pressure via the Governor function switch.
Refer to chapter "Adjust water pump pressure".
Or
► Adjust the output pump pressure via the automatic pump pressure
governor.
Refer to chapter "Pump pressure regulator".
7.8.5 Mount lighting system frame holder
To ensure operational safety, the Rosenbauer LED lighting system can only
be turned on when the propulsion engine is running and the battery voltage
is greater than 11.5 V.
► Fix the frame holder to both rear slots on the carrying frame by sus-
pending the straps.
Frame holder is mounted.
► Insert the extension poles of the Rosenbauer LED lighting system into
the frame holder.
For fastening at least 2 extension poles of the Rosenbauer LED
system are required.
► The extensions are individually locked by twisting, to prevent ac-
cidental loosening or the lighting head falling down.
► Mount the lighting head on the extension poles.
► Connect the cable to the Rosenbauer LED lighting system socket.
Rosenbauer LED lighting system can be operated.
To Next Page
Loading...
