Reader Functionality
AYC-E/Q/T60 Family Installation and Programming Manual 23
5.2.1 Entering Programming Mode
To reach the Programming Menu System, the AYC-E/Q/T60 must first
be placed into Programming mode.
To enter Programming mode:
1. Press # four times.
Transmit LED turns off.
Program LED turns red.
2. Enter your Programming code.
If the Programming code is valid,
the door LED turns green and the
AYC-E/Q/T60 is in Programming
mode.
• The factory 4-digit Programming code is 1234.
• If a Programming code is not entered within 30 seconds, the AYC-
E/Q/T60 returns to Transmit mode.
5.2.2 Exiting Programming Mode
To exit Programming mode:
1. Press #.
You hear a beep.
The Program LED is off.
The Transmit LED turns red.
This indicates that the AYC-E/Q/T60 has returned to Transmit
mode.
Wrong entries may reset the reader back to Transmit mode.
While in Programming mode, if no key is pressed for 30 seconds,
the AYC-E/Q/T60 exits Programming mode and returns to
Transmit mode.
To Next Page
Loading...
