Reader Functionality
AYC-E/Q/T60 Family Installation and Programming Manual 35
5.2.11 Return to Factory Default Settings
You must be very careful before using this command! This
erases the entire memory and returns all codes to their
factory default setting.
To return to factory default settings:
1. Enter Programming mode.
2. Press 0 to enter Menu 0.
The Transmit LED flashes red.
The Program LED flashes red.
3. Enter your Programming code.
If the Programming code is valid, all memory is erased, you hear
three beeps and the controller returns to Normal mode.
If the Programming code is invalid, you hear a long beep and the
controller returns to Normal mode without erasing the memory of
the controller.
5.2.12 Replacing a Lost Programming Code
In the event that the Programming code is forgotten, the AYC-
E/Q/T60 may be reprogrammed in the field using the following
instructions:
To replace a lost Programming code:
1. Remove power from the reader.
2. Activate the tamper by removing the reader from the wall or
removing the reader's case.
3. Apply power to the reader.
4. You now have 10 seconds to enter Programming mode using the
factory default Programming code 1234.
To Next Page
Loading...
Need help?
General
