Controller Functionality
44 AYC-E/Q/T60 Family Installation and Programming Manual
6.10.3 Changing Lock Strike Code
The Lock Strike code is mainly used as a method to quickly test the
Lock Strike Relay during installation.
When the first user is added to the controller, the default Lock Strike
code is automatically deleted. Once the code is programmed again, it
is not deleted with the entry of additional User codes.
To change the Lock Strike code:
1. Enter Programming mode.
2. Press 1 to enter Menu 1.
The Mode LED turns red.
3. Enter the new code you wish to
set as the Lock Strike code.
You hear three beeps.
The system returns to Normal
mode.
• Lock Strike code does not work in the Secure mode.
• Wrong entries return the controller to Normal mode.
• Code 0000 erases the Lock Strike code.
• The factory DEFAULT 4-digit Lock Strike code is 2580.
6.10.4 Changing Auxiliary Code
The Auxiliary code is mainly used as a method to quickly test the
Auxiliary Relay during installation.
To change the Auxiliary code:
1. Enter Programming mode.
2. Press 2 to enter Menu 2.
To Next Page
Loading...
Need help?
General
