EasyManuals Logo

Rotax 912 i series Installation Manual

Rotax 912 i series
206 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
d05150.fm
INSTALLATION MANUAL
BRP-Powertrain
Effectivity: 912 i Series
Edition 1/Rev. 0
INTRO
page 1
January 01/2012
Chapter: INTRO
GENERAL NOTE
Foreword Before starting with the engine installation, read this Installation Manual
carefully. The Manual will provide you with basic information on correct
engine installation, a requirement for safe engine operation.
If any passages of this Manual are not clearly understood or if you have
any questions, please contact an authorized distributor- or Service
Center for ROTAX aircraft engines.
BRP-Powertrain GmbH & Co KG (hereinafter “BRP-Powertrain“) wishes
you much pleasure and satisfaction flying your aircraft powered by this
ROTAX aircraft engine.
Chapter structure The structure of the Manual follows whenever it is possible the structure
of the ATA (Air Transport Association) standards. The aim is the compat-
ibility with the aircraft manufacturer's documentation, which means they
must then adapt the documentation to their standard.
The Installation Manual is subdivided into the following chapters:
Subject Chapter
Introduction
Chapter INTRO
List of effective pages
Chapter LEP
Table of amendments
Chapter TOA
General note
Chapter 00-00-00
Storage & Installation
Chapter 10-10-00
Electric system
Chapter 24-00-00
Propeller drive
Chapter 61-00-00
Engine
Chapter 72-00-00
Fuel system
Chapter 73-00-00
Ignition system
Chapter 74-00-00
Cooling system
Chapter 75-00-00
Engine management
Chapter 76-00-00
Exhaust system
Chapter 78-00-00
Lubrication system
Chapter 79-00-00
Electric starter
Chapter 80-00-00

Table of Contents

Other manuals for Rotax 912 i series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rotax 912 i series and is the answer not in the manual?

Rotax 912 i series Specifications

General IconGeneral
Number of Cylinders4
Max Power100 hp (73.5 kW)
Max Power Output RPM5800 rpm
Ignition SystemDual electronic ignition
Oil SystemDry sump, forced lubrication with separate oil tank
Reduction Gear Ratio2.43:1
TBO2000 hours
Engine Type4-stroke, horizontally opposed
Displacement1352 cm³
Bore x Stroke84 mm x 61 mm
Max Torque128 Nm
Fuel TypeAvgas 100LL or unleaded automotive gasoline
Fuel SystemElectronic fuel injection
Cooling SystemLiquid/air-cooled

Related product manuals