Roto NT Power Hinge - Security

12
.
July 2014
.
IMO_347_EN_v0 Roto NT Subject to change.
Security
Stipulated use
Turn-Only and Tilt&Turn hardware is one-hand operation Turn-Only and
Tilt&Turn hardware for windows and balcony doors in building construction.
This is used to enable windows and balcony-door sashes into a turning
position
by operating a ‘hand-lever’ (handle) or into a limited tilting position
in the case of the scissors (sash-stay) version. Turn-Only and Tilt&Turn
hardware
is used on vertically installed windows and balcony-doors made of
timber, PVC, aluminium or steel and their corresponding material combina-
tions.
Turn-Only and Tilt&Turn hardware as covered by this definition, locks
window and balcony door sashes or enables various ventilating positions.
When closing, the gasket counter force must be overcome as a rule.
Correct use also includes adhering to all the specifications in the product-
specific documents, such as:
– These
Installation, maintenance and operation instructions
– Product catalogues
– Information and specifications of the profile manufacturer (e.g. PVC or
light metal profiles etc.)
– The relevant directives TBDK and VHBE of the Quality Assurance Association:
Locks and Hardware (Gütegemeinschaft Schlösser und Beschlägee.V.)
– The valid national laws and directives
Any type of use that goes beyond or differs from the defined correct use
shall be regarded as misuse.
WARNING!
Danger from misuse!
Misuse and incorrect installation of hardware can result in
hazardous
situations.
– Never use hardware combinations that have not been approved
by the hardware manufacturer.
– Never use accessories that are not original products or that
have not been approved by the hardware manufacturer.