Subject to change. Roto NT IMO_347_EN_v0
.
July 2014
.
55
Hardware overview
NT Designo (timber, PVC) – Turn-Only / Tilt&Turn hardware
Basic security
4 mm clearance
5
Corner drive 1 V 260272
5a
Corner drive, T&T 1 V 260288
8
Multipart centre lock, bottom horizontal
1)
SRW / mm SRH / mm Size Material no.
801 – 1000 200 1 V 296853
17
Packer 622615
16
Run-up block 350402
14
Corner hinge 634705
15
Pivot rest, timber and PVC profiles,
axis 13 mm, rebate depth 24 mm
2)
L 563737
R 563736
Profile-related components
6
Tilt striker threshold set Eifel 13mm
2-sashed centre
730427
7
Tilt striker threshold set Eifel 13mm 534929
1) Not required with timber profiles.
2) With PVC profiles, observe the installation advice on page 80.
Application range
Sash rebate width SRW act. sash (T&T) .........600 – 1000 mm
Sash rebate width SRW pass. sash (TU-ON)
.600 – 1000 mm
Sash rebate height SRH .................................. 1600 – 2600 mm
Sash weight S.kg ...................................................max. 100 kg
NOTE!
This document excerpt does not replace the
complete product documentation*. Non-com-
pliance exempts the hardware manufacturer of
his liability.
For all other Tilt&Turn hardware components
refer to:
CTL_6_EN, CTL_7_EN
* Can be found on www.roto-frank.com
To Next Page
Loading...