Subject to change. Roto NT IMO_347_EN_v0
.
July 2014
.
7
General information
Information on these instructions
Marking Explanation
BA Hardware axis
BZ Supporting-pins
DIN L / R DIN left/right
T&T Tilt&Turn hardware
SRW Sash rebate width
SRH Sash rebate height
S.kg Sash weight
CON Connectable
CL Centre lock
LMD Lifting mishandling device
not dep. not depicted
RC1/RC1N Resistance Class 1
RC2/RC2N Resistance Class 2
SEC Security
All dimensions stated in mm. Other values are specified.
Protection of copyright
The contents of this manual are protected by copyright. In the framework
ofthe hardware manufacturing, the use of the contents is allowed. Any
other or further use is not permitted without written permission of the
manufacturer .
To Next Page
Loading...