Roto NT Power Hinge - Page 96

96
.
July 2014
.
IMO_347_EN_v0 Roto NT Subject to change.
Protection against (permanent) moist interior air
Specialist
company
End-users
Ventilate the hardware and the rebate areas –
especially in the construction phase –
so that
they are neither exposed to direct contact
with water nor to formation of condensation
water.
Ensure that (permanently) damp spatial air
cannot condense in the hinge and rebate
areas :
 Force ventilate several times each day
(open all windows for approx. 15minutes).
 Also ventilate during holidays and absences.
 For more complex construction projects,
develop a ventilation plan if necessary.
If described systematic ventilation is not
possible , e.g. because fresh screed must not
be traversed, or it cannot take draughts, put
the windows into the tilted position and make
them airtight by taping on the indoor side.
Divert
the moisture present in the room air to
the outside by means of condensation dryers.
= To be carried out only by a specialist company
–
= Not to be carried out by the end-user; the end-user may not carry out installation work!
= To be carried out either by a specialist company or by the end-user.
Protection against damages due to renovation work
Specialist
company
End-users
When applying surface treatments of the
windows, exclude all hardware components
from this treatment, and thus protect against
contamination.
Use only adhesive tapes which do not
damage the varnish layers. In the case of
doubt, ask the window fabricator.
= To be carried out only by a specialist company
–
= Not to be carried out by the end-user; the end-user may not carry out
installation work!
= To be carried out either by a specialist company or by the end-user.
Maintenance
Preservation of the surface finish