Chapter 2 • Introduction
13
COMPUTER LINK
This button displays a window that allows you to put the TheaterTouch into
Computer Link
mode.
This is used for RS-232 communications between a personal computer and the
TheaterTouch for loading a program into the TheaterTouch or extracting a
program from the TheaterTouch.
The two options available for the transfer of a program in the TheaterTouch
Designer software are:
♦
Send File to Remote,
which sends the new program from the software
to the remote, overwriting
the existing program.
♦
Receive File from Remote,
which extracts a copy
of the program from
the remote to the software, leaving the program in the remote intact
.
Press the
OK
button to close the window after the transfer is complete.
To Next Page
Loading...
