Sam4s SPT-3000 User Manual

4-4
In case, the user requires to expand the capacity of system memory, the specification of memory should first be checked. Memory size can be
decided a maximum of 2GB, depending upon the specification of its main board. Once the memory is installed, BIOS automatically recognizes
the memory type, capacity and speed.
System should be turned off for expanding memory.
※Cables for power & peripherals should be disconnected prior to system disassemble.
1
System back cover should be taken off, referring System Dismantle.
2
3
Upgrading Memory Module
Upgrading Memory Module
Help Printer
Exit
Content
Introductions
Hard Disk Drive
Internal Speaker
SD Card & USB Board
Inverter Module
Touch & MSR Board
LED Board
Power Board
Main Board
Touch Panel and TFT-LCD
Magnetic Dallas (Option)
Getting Started
Using this system
BIOS Setup
How to use PDF
HOME
Introductions
System Disassemble
System Reassemble
Memory Module
Hard Disk Drive
Internal Speaker
SD Card & USB Board
Inverter Module
Touch & MSR Board
LED Board
Power Board
Main Board
Touch Panel and TFT-LCD
Magnetic Dallas (Option)
Getting Started
BIOS Setup
How to use PDF
HOME
Exploded View
and Replaceable
parts
Using this system
Removal and
Replacement
Magnetic Stripe Reader
(MSR)
e-manual
Lever
Install new memory as shown in the figure and tighten them with levers at both ends.

Sam4s SPT-3000 Specifications

General

Brand	Sam4s
Model	SPT-3000
Category	Touch terminals
Language	English