Primary IDE Slave
Type
Press PgUp/<+> or PgDn/<-> to select [Manual], [None] or [Auto] type.
Note that the specifications of your drive must match with the drive table.
The hard disk will not work properly if you enter improper information for this
category. If your hard disk drive type is
not matched or listed, you can use
[Manual] to
define your own drive type manually.
LBA/Large Mode
Enabling LBA causes Logical Block Addressing to be used in place of
Cylinders, Heads and Sectors
Any selection except Disabled determines
the number of sectors transferred
per block
.
Indicates the type of PIO (Programmed Input/Output)
Indicates the type of Ultra DMA
This allows you to activate the S.M.A.R.T.(Self-Monitoring Analysis & Reporting
Technology) capability for the hard disks. S.M.A.R.T is a utility that monitors your
disk status to predict hard disk failure.
Enables 32-bit communication between CPU and IDE device
Block(Multl-Sector Transfer)
PIO Mode
DMA Mode
S.M.A.R.T
32 Bit Date Transfer
To Next Page
Loading...
Need help?
General
