Sam4s SPT-3000 - Serial Port

Getting Started
Using this system
HOME
Introductions
Removal and
Replacement
BIOS Setup
Exploded View
and Replaceable
parts
How to use PDF
e-manual
System Set up
Help Printer
Exit
Content
Super IO Configuration
A-1
1
(1/2/3/4/5/6 Address, Serial Port 1/2/3/4 IRQ)
Select an address and a corresponding interrupt for the serial port.
This setting specifies the serial port5 mode.
Select an address for the parallel port.
You can enable the system watch-dog timer, a hardware timer that generates
either an NMI or a reset when the software that it monitors does not respond
as expected each time the watch dog polls it.
Serial Port
Serial Port5 Mode
Parallel Port Address
Watch Dog