Alignment & Adjustment
3-2 Samsung Electronics
3-2 How to Access Service Mode
1. Turn off the power to put the unit into the STAND-BY mode.
2. In order to enter the Service Mode, Press "Mute" → "1” → "8" → "2" → "POWER" button on the Remote Control.
In case entry into SERVICE MODE is unsuccessful, repeat the procedures above.
3. Initial DISPLAY State in times of Service Mode Switch overs
4. Buttons operations within Service Mode
OPTION CHECKSUM
DDP3021 SERVICE
CCA(OFF)
SP Actuator
DNIE
TC90103
SAA7119
MST33X9
SDP51(M)
SDP51(S)
SDP52
S5H2200
KS1409-TUNER
STV82X8
Cinema CCA
ESP
T_GALIAUS0_00XX
2006_XX_XX
T-GALIUCOM5-60XX
T-GAIAUS1_XX
MENU Full Menu Display / Move to Parent Menu
Direction keys ▲ / ▼
Item Selection by Moving the Cursor
Direction keys ◀ / ▶
Data Increase/Decrease for the Selected Item
Source Cycles through the active input source that are connected to the unit
Enter Item Selection/execution
To Next Page
Loading...
Need help?
General