Sanremo Opera - Page 48

06-2017
16 / 24
OPERA
CAP. 5
Operation of the machine
EN
The operation of the cup heating plate and the power
of the heating element can be set with this function.
The grams of coffee, quantity of water and dispensing
pressure can be set with this function for each type
and % of dispensing.
Pre-infusion and post-infusion can be set with this
function for each type and % of dispensing.
All machine parameters can be downloaded on the
tablet with this function, updating those stored in the
memory.
The new operating settings can be sent from the tablet
to the machine with this function.
This allows connecting the tablet to the machine with
a Bluetooth connection.
Disconnect the Bluetooth connection.
Connection to the machine
Press the “Connect” button to display the fol-
lowing screen with the pre-set connection address:
in order to connect the machine to the tablet, press
the displayed connection; the STATUS bar located on
the bottom of the screen will say “Connected to SAN-
REMOXXXX” and the main screen will be displayed.
Data reading
• Before performing any operation, the machine set-
tings must be read by pressing the “Read Machine”
button
; the message “Reading” appears
in the middle of the screen; when all data have been
fully transferred from the machine to the software, the
“Reading Completed” message will be displayed.
Timer
• Press the “Timer” button to display the following
screen:
Start
• The “Start” function can be used to set the time for
automatic start of the machine.
• Press arrow “>” on the right side of the screen near
the “Start” button to display the following screen:
• Enable the “No start” function to prevent the machine
from starting automatically; enable the “Automatic
start” function to set the start time of the machine in
therelevantelds;press“OK”toconrmandreturn
to the main screen of the “Timer” function.