Santec TSL-210 - Page 64

TUNABLE LD LIGHT SOURCE TSL-210
10-9
AT
1. Sets output variable of ATT. 1. AT
-
*3
2. Sets ATT number to numeric data appended to
command. Value range is 0~20.
2. AT X X . X X
3. Sets ATT mode to manual control mode. 3. ATD
4. Sets ATT mode to automatic control mode. 4. ATE
*1 When wavelength is set by WA command, ne tuning is turned off and FT value ise set back to 0.
*2 When supplying or intercepting current to LD, it takes time to set the internal processing. The status
changes when the processing nishes.
*3 This command can be set only when in ACC or ATT manual mode.
mW/dBm
nm
mW

dBm
LD
COH SHIFT
OPTION ACC
SIF
WAVE LENGTH
POWER
LOCAL
OPT.OUT
TUNABLE SEMICONDUCTOR LASER TSL-210
TEMP.ERROR
CURR.LIMIT
WAVE
LENGTH
POWER
santec
3
4
5
6
7
1
2
Key Index
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com