Santec TSL-770 - Setting Address, Delimiter, and Command Set

Tunable Semiconductor Laser TSL-770
7-3
■
7-1-3.
Setting the Address, Delimiter, and Command set
1. Touch MENU , NEXT , COM , and GPIB . The GPIB settings screen will be
displayed.
2. Set GPIB address and delimiter.
Address: Set a unique value from 1 to 30. The default value is 1.
Delimiter: Select a delimiter from ”CR”, ”LF”, ”CR+LF”, and ”EOI “.
Set the end character of the command string. When “CR”, ”LF” or
”CR+LF” is selected, the command is accepted and analysis begins when
the specied delimiter is received. When a command is sent, the delimiter
is added to the end of the command and an EOI signal is asserted. When
“EOI” is selected, the command is accepted and analysis begins when
the EOI is received. When a command is sent, an EOI is asserted when
the last character is sent.