Santec TSL-770 - Installing a VCP Driver Software

Tunable Semiconductor Laser TSL-770
7-9
■
7-2-4. Installing a VCP Driver Software
To enable VCP communication, VCP driver software must be installed.
1. After installed USB driver software by 7-2-3, open “Device Manager” (Figure 7-2-4-
1),and open “Santec USB TSL-770” under “Universal Serial Bus Controllers”. Right-
click on “Santec USB TSL-770” and click on “Properties”.
2. Check “Load VCP” in “Advanced” tab.
Figure7-2-4-2. Santec USB TSL-770 Properties
Figure7-2-4-1. Device Manager