SANY SRT45 - Maintenance Inspection Form for 1500 Hrs

SRT45 Off-Highway Truck
8-51
Safety, Operation and Maintenance Manual
8.6.15 Maintenance inspection form for 1500hrs
Except daily (10hrs) inspection projects, the following projects also have to nish after running
1500hrs.
1. For normally checking
Check leakages, loosened and damaged parts for truck.……….........…………………………
Observe the cracks and welder seam for frame……………................................................…
2. Cummins engine
Check the fasteners for engine………………………………………...........................…………
Check PTO liquid level, rell as required……………………..…………..............………………
Drain, replace lter and rell………………………………..................………………………..…
Check breather valve for crankcase………………………................………….......……………
Fuel system
Replace fuel lter…………………………………………………………………….………………
Cooling system
Replace coolant lter………………………………………………………………………..………
Check and supplement DCA to coolant…………….….......................................................….
3. Transmission
Check the status of the pin of injector, tighten it if required.…….........................……..………
Clean the breather valve for transmission and lubricates again.……...........……..…......……
Check status about block caution lamp for lter.……………………................................…….
Remark:
drain, replace lter and rell after 150hrs, if transmission has been xed.
4. Front brake system
Check status about disc worn to determinate replace it if required.……....……………………
5. Main reducer and differential assembly,Planetary assembly and power take-off (PTO)
Extract lubrication sample from Main reducer and differential assembly and Planetary assembly
for checking and analysis....................................................................................................…
Check liquid level, rell as required…………………………………………......…………………
Check and clean the breather valve for rear axle.………………..............………………
Check and clean the breather valve for PTO……………………….............…………...…
Remark:
change oil when replace new one or after xed.
6. Lubrication
Front, rear transmissions cross shafts…………….......................…………..................……..4 points
Front, rear transmission shafts………………………….......………………….................…….2 points
7.Clean up the dust on the pin shaft of foot-operated valve,and add the lubricating oil…...…
Checker Date
Remarks
Lubrication and Servicing
Courtesy of Machine.Market