SANY SRT45 - Maintenance Inspection Form for 3450 Hrs

SRT45 Off-Highway Truck
8-97
Safety, Operation and Maintenance Manual
8.6.33 Maintenance inspection form for 3450hrs
Except daily (10hrs) inspection projects, the following projects also have to nish after running
3450hrs.
1. For normally checking
Check leakages, loosened and damaged parts for truck.……….........…………………………
Observe the cracks and welder seam for frame……………................................................…
2. Cummins engine
Check the fasteners for engine………………………………………...........................…………
Check PTO liquid level, rell as required……………………..…………..............………………
3. Transmission
Clean the breather valve for transmission and lubricates again.…….................……..………
Check status about block caution lamp for lter.……………………................................…….
Remark:
drain, replace lter and rell after 150hrs, if transmission has been xed.
4. Main reducer and differential assembly,Planetary assembly and power take-off (PTO)
Extract lubrication sample from Main reducer and differential assembly and Planetary assembly
for checking and analysis……………………………………………………......…………………
Check liquid level, rell as required…………………………………………......…………………
Check and clean the breather valve for rear axle.………………..............………………
Check and clean the breather valve for PTO……………………….............…………...…
Remark:
change oil when replace new one or after xed.
5.Steering
Check screw between steering arm and front suspension cylinder. If loosed or damaged ,tighten or
replace new screw.……..................………………………………………………………..………
6.Clean up the dust on the pin shaft of foot-operated valve,and add the lubricating oil…...…
Checker Date
Remarks
Lubrication and Servicing
Courtesy of Machine.Market