Safety
Safety, Operation and Maintenance Manual
2-37
SRT45 Off-Highway Truck
2.3.3 Transportation
This machine must be disassembled
for transportation. When transporting the
machine, please consult your Sany distributor.
2.3.3.1 Loading and unloading the machine
Improper loading and unloading of the
machine may cause it to fall or tip over. Follow
the procedures below:
●
Load or unload the machine only on
a solid and flat surface.Keep it a safe
distance away from road sides or a cliff.
●
Keep on-lookers away.
●
U se a n acc es s r am p w it h e no ugh
strength.Make sure that the width, length
and thickness of the access ramp is
capable of providing a safe loading/
unloading operation(at an angle ≤ 15°).
●
Make sure the access ramp is free from
grease, oil, water and debris. Clean the
track if necessary. Be extremely careful
when loading or unloading the machine in
rainy or snowy weather.
●
Run the engine at low speed and operate
slowly.
●
Gravity center of the machine may alter
when it passes the jointing area between
the ramp and the trailer. The machine may
tilt at this moment. Travel slowly when the
machine is on the joint area.
●
Never reposition the machine on the
access ramp. If necessary, drive it off the
ramp, reposition, and get on the ramp
again.
●
When loading or unloading the machine
on a platform, make sure the platform has
adequate width, strength and a proper
grade.
●
Once the machine is loaded, lock the cab
door. Otherwise, it may swing open during
transportation.
Space
Blocks
Max. Angle15°
Fig. 2.3-16
To Next Page
Loading...