SANY SRT45 - Maintenance Inspection Form for 3600 Hrs

SRT45 Off-Highway Truck
8-101
Safety, Operation and Maintenance Manual
8.6.35 Maintenance inspection form for 3600hrs
Except daily (10hrs) inspection projects, the following projects also have to nish after running
3600hrs.
1. For normally checking
Check leakages, loosened and damaged parts for truck.……….........…………………………
Observe the cracks and welder seam for frame……………................................................…
Check displacement and worn for transmission shaft by lever.……….....................…….……
2. Lubrication
Front, rear transmissions cross shafts………………….……......................…..................…..4 points
Front, rear transmission shafts…………………………………………......…….................…..2 points
Checking and ensure of all lubrication points work well……...............................................…
3. Electrical system
Check harnesses status.………………………………..................………………………………
Check status about cables for storage battery……………………………………………………
Tighten for alternator and generator……………................………………………………………
4. Cummins engine
Check the fasteners for engine………………………………………...........................…………
Check PTO liquid level, rell as required……………………..…………..............………………
Air cleaner………………………………………………………………....…………………………
Clean pipeline and lter for air cleaner............................………………………………..………
5. Transmission
Clean the breather valve for transmission and lubricates again.…….................……..………
Check status about block caution lamp for lter.……………………................................…….
Remark:
drain, replace lter and rell after 150hrs, if transmission has been xed.
6. Main reducer and differential assembly,Planetary assembly and power take-off (PTO)
Extract lubrication sample from Main reducer and differential assembly and Planetary assembly
for checking and analysis....................................................................................................…
Check liquid level, rell as required…………………………………………......…………………
Check and clean the breather valve for rear axle.………………..............………………
Check and clean the breather valve for PTO……………………….............…………...…
Remark:
change oil when replace new one or after xed.
7. Fuel tank
Rain ,clean it and relling…………...…......................................……….............…………...…
8.Clean up the dust on the pin shaft of foot-operated valve,and add the lubricating oil…...…
Checker Date
Remarks
Lubrication and Servicing
Courtesy of Machine.Market