SRT45 Off-Highway Truck
8-125
Safety, Operation and Maintenance Manual
8.6.42 Maintenance inspection form for 10000hrs
Except daily (10hrs) inspection projects, the following projects also have to nish after running
10000hrs.
According to the sample of the oil to determinate whether replace components or not.
1. Engine
Contacting with manufacturer for further information..............................………………………
2. Transmission
Disassemble, inspect and x or replace some parts if required which parts has been worn.............
............................................................................................................................................…
Remark:
drain, replace lter and rell after 150hrs, if transmission has been xed.
3. Main reducer and differential assembly,Planetary assembly
Disassemble, inspect and x or replace some parts if required which parts has been worn.…........
........................................................................................................................................……
4. Bearing
Replace new bearings for steering drag link......................................................................….
Replace new bearings for A-shape arm.............................................................................….
Replace new bearings for ends of the A-shape arm..........................................................….
Replace new bearings for steering cylinder........................................................................….
Check the wearing status for oscillating bearings of front suspension cylinder , replace new one if
the clearance of the bearing S≥ 0.55mm .Conversely, you could continue to use it
.….......................................................................................................................................…
Check the wearing status for oscillating bearings of rear suspension cylinder , replace new one if
the clearance of the bearing S≥ 0.63mm .Conversely, you could continue to use it
.….......................................................................................................................................…
Check the wearing status for oscillating bearings of link , replace new one if the clearance of the
bearing S≥ 0.63mm .Conversely, you could continue to use it
.….......................................................................................................................................…
Check the wearing status for oscillating bearings of A-shape , replace new one if the clearance of
the bearing S≥ 0.84mm .Conversely, you could continue to use it
.….......................................................................................................................................…
5.Steering
Check screw between steering arm and front suspension cylinder. If loosed or damaged ,tighten or
replace new screw.……..................…………………………………………………...………..…
6.Clean up the dust on the pin shaft of foot-operated valve,and add the lubricating oil…...…
Checker Date
Remarks
Lubrication and Servicing
To Next Page
Loading...