SRT45 Off-Highway Truck
8-85
Safety, Operation and Maintenance Manual
8.6.29 Maintenance inspection form for 3000hrs
Except daily (10hrs) inspection projects, the following projects also have to nish after running
3000hrs.
1. For normally checking
Check leakages, loosened and damaged parts for truck.……….........…………………………
Observe the cracks and welder seam for frame……………................................................…
Check displacement and worn for transmission shaft by lever.……….....................…….……
2. Lubrication
Front, rear transmissions cross shafts………………….……......................…..................…..4 points
Front, rear transmission shafts…………………………………………......…….................…..2 points
Checking and ensure of all lubrication points work well......................................................…
3. Electrical system
Check harnesses status.………………………………..................………………………………
Check status about cables for storage battery……………………………………………………
4. Cummins engine
Check fasteners for engine, tighten them if required………………...........................…………
Check oil level for PTO, rell as required.………………..…………...................………………
Drain, replace lter and rell.………………………………………….....…………………………
Check breather valve for crankcase........................…………….……………......……..………
Fuel system
Replace fuel lter…………………………………………………………………….………………
Cooling system
Replace coolant lter………………………………………………………………………..………
Check and supplement DCA to coolant…………….….......................................................….
Air cleaner
Clean pipeline and lter for air cleaner.…………….…........................................................….
5.Steering
Check screw between steering arm and front suspension cylinder. If loosed or damaged ,tighten or
replace new screw.……..................………………………………………………………..………
6.Clean up the dust on the pin shaft of foot-operated valve,and add the lubricating oil…...…
Checker Date
Remarks
Lubrication and Servicing
To Next Page
Loading...