SANY SRT45 - Maintenance Inspection Form for 1800 Hrs

SRT45 Off-Highway Truck
8-59
Safety, Operation and Maintenance Manual
8.6.18 Maintenance inspection form for 1800hrs
Except daily (10hrs) inspection projects, the following projects also have to nish after running
1800hrs.
1. For normally checking
Check leakages, loosened and damaged parts for truck.……….........…………………………
Observe the cracks and welder seam for frame……………................................................…
Check displacement and worn for transmission shaft by lever.……….....................…….……
2.Lubrication
Check and ensure of all lubrication points work well………….....................………….………
3. Electrical system
Check harnesses status.………………………………..................………………………………
Check status about cables for storage battery……………………………………………………
4. Cummins engine
Check the fasteners for engine………………………………………...........................…………
Check PTO liquid level, rell as required……………………..…………..............………………
Air cleaner………………………………………………………………....…………………………
Clean pipeline and lter for air cleaner............................………………………………..………
5. Transmission
Clean the breather valve for transmission and lubricates again.……...........…......…..………
Check status about block caution lamp for lter.……………………................................…….
Remark:
drain, replace lter and rell after 150hrs, if transmission has been xed.
6. Differential, planetary gearing and power take-off (PTO)
Extract lubrication sample from Main reducer and differential assembly and Planetary assembly
for checking and analysis....................................................................................................…
Check liquid level, rell as required…………………………………………......…………………
Check and clean the breather valve for rear axle.………………..............………………
Check and clean the breather valve for PTO……………………….............…………...…
Remark:
change oil when replace new one or after xed.
7. Fuel tank
Drain, clean and rell………………………………………..........................................…………
8.Clean up the dust on the pin shaft of foot-operated valve,and add the lubricating oil…...…
Checker Date
Remarks
Lubrication and Servicing
Courtesy of Machine.Market