SANY SRT45 - Maintenance Inspection Form for 3750 Hrs

SRT45 Off-Highway Truck
8-103
Safety, Operation and Maintenance Manual
8.6.36 Maintenance inspection form for 3750hrs
Except daily (10hrs) inspection projects, the following projects also have to nish after running
3750hrs.
1. For normally checking
Check leakages, loosened and damaged parts for truck.……….........…………………………
Observe the cracks and welder seam for frame……………................................................…
2. Cummins engine
Check the fasteners for engine………………………………………...........................…………
Check PTO liquid level, rell as required……………………..…………..............………………
Drain, replace lter and rell………………………………..................………………………..…
Check breather valve for crankcase……………………….......................………………………
Fuel system
Replace fuel lter…………………………………………………………………….………………
Cooling system
Replace coolant lter………………………………………………………………………..………
Check and supplement DCA to coolant…………….….......................................................….
3. Transmission
Clean the breather valve for transmission and lubricates again.……...........…......…..………
Check status about block caution lamp for lter.……………………................................…….
Remark:
drain, replace lter and rell after 150hrs, if transmission has been xed.
Check the driveline bolts torque(rst time after 150hrs, next time after each 1200hrs)….…..
Bolt code Use of the site
Tightening torque
(N·m)
Check torque
(N·m)
60011099 Front driveline 145 140
60011098 Rear driveline 230 220
Caution:
The scene conducts the driveline assembly:
Upon assembly, the rst, cleaning threaded hole oil of driveline and yoke to install.
At the beginning of operation, three consecutive days of checking the driveline bolts torque.
Checker Date
Remarks
Lubrication and Servicing
Courtesy of Machine.Market