Sanyo PLC-WXU700 - Remote Control Battery Installation; Remote Control Operating Range; Remote Control Code

13
Part Names and Functions
Toensuresafeoperation,pleaseobservethefollowingprecautions:
 ● Usetwo(2)AAAorLR03typealkalinebatteries.
 ● Alwaysreplacebatteriesinsets.
 ● Donotuseanewbatterywithausedbattery.
 ● Avoidcontactwithwaterorliquid.
 ● Donotexposetheremotecontroltomoistureorheat.
 ● Donotdroptheremotecontrol.
 ● Ifthebatteryhasleakedontheremotecontrol,carefullywipethecasecleanandinstallnewbatteries.
 ● Riskofanexplosionifbatteryisreplacedbyanincorrecttype.
 ● Disposeofusedbatteriesaccordingtotheinstructionsoryourlocaldisposalruleorguidelines.
Pressthelid
downwardandslideit.
Openthebattery
compartmentlid.
Installnewbatteries
intothecompartment.
Replacethe
compartmentlid.
Two AAA size batteries
Forcorrectpolarity
(+and–),besure
batteryterminalsare
incontactwithpinsin
compartment.
1 2 3
Pointtheremotecontroltowardtheprojectorwhenpressing
thebuttons.Maximumoperatingrangefortheremote
controlisabout16.4'(5m)and60degreesinfrontofthe
projector.
Remote Control Operating Range
Remote Control Battery Installation
16.4'
(5m)
30°
Remotecontrol
30°
WhilepressingtheMENU
button,presstheIMAGE
buttonnumberoftimes
correspondingtotheremote
controlcode.
MENU button
IMAGE button
RESET/ON/ALL-
OFF switch
Remote Control Code
Remote Control Code
Number of Times
Pressing IMAGE
Button
Code 1 1
Code 2
2
Code 3 3
Code 4 4
Code 5 5
Code 6 6
Code 7 7
Code 8 8
Theeightdifferentremotecontrolcodes(Code1–Code8)areassignedtothisprojector.Switchingtheremote
controlcodespreventsinterferencefromotherremotecontrolswhenseveralprojectorsorvideoequipment
nexttoeachotherareoperatedatthesametime.Changetheremotecontrolcodefortheprojectorfirstbefore
changingthatfortheremotecontrol.See"Remotecontrol"intheSettingMenuonpage58.
WhilepressingtheMENUbutton,presstheIMAGE
buttonnumberoftimescorrespondingtotheremote
controlcode.Seethelistbelow.
1
Toinitializetheremotecontrolcode,slidetheRESET/
ON/ALL-OFFswitchtoRESET,andthentoON.The
initialcodeissettoCode 1.
2