Sanyo PLC-WXU700 - Computer Input; Input Source Selection (Computer 1:Rgb;Component;Rgb(Scart))

30
ChooseComputer 1 bypressingtheINPUTbuttononthetopcontrolorpresstheCOMPUTERbuttononthe
remotecontrol.
Beforeusingthesebuttons,correctinputsourceshouldbeselectedthroughMenuoperationasdescribed
below.
1
Input Menu
2
3
Input Source Selection (Computer 1: RGB / Component / RGB(Scart) )
Computer Input
Note:
  WhentheInputSearchfunctionissetto On1orOn2in
theAutosetupfunction,theinputsignalwillbesearched
automatically(p.48).
Computer
1
Top Control
INPUT button
Direct Operation
Menu Operation
PresstheMENUbuttontodisplaytheOn-Screen
Menu.UsethePoint▲▼buttonstoselectInputand
thenpressthePoint►ortheSELECTbutton.
UsethePoint
▲▼buttonstoselectComputer 1and
thenpressthePoint►buttontoaccessthesubmenu
items.
WhenComputer 1isselected,usethePoint▲▼
buttonstoselectRGBandthenpresstheSELECT
button.
COMPUTER button
Remote Control
Computer 1
Computer 2

Computer 1
HDMI
Computer 2

S-video
Network
Video

COMPUTER 2cannotbeselectedwhenusingtheCOMPUTERIN2/
MONITOROUTterminalasMONITOROUToutput.