Sanyo PLC-WXU700 - Input Source Selection (Computer 2:RGB)

31
Computer Input
ChooseComputer 2 bypressingtheINPUTbuttononthetopcontrolorpresstheCOMPUTERbuttononthe
remotecontrol.
Beforeusingthesebuttons,correctinputsourceshouldbeselectedthroughMenuoperationasdescribed
below.
Input Source Selection (Computer 2: RGB)
Direct Operation
Menu Operation
Note:
 WhentheInputSearchfunctionissettoOn1orOn2,
theinputsignalwillbesearchedautomatically(p.48).
1
2
3
PresstheMENUbuttontodisplaytheOn-Screen
Menu.UsethePoint▲▼buttonstoselectInputand
thenpressthePoint►ortheSELECTbutton.
UsethePoint
▲▼buttonstoselectComputer 2and
thenpresstheSELECTbutton.
WhenComputer 2isselected,analogRGBinput
sourcewillbeselecteddirectly.
Input Menu
Top Control
INPUT button
Computer 1
HDMI
Computer 2

S-video
COMPUTER button
Remote Control
Computer 1
Computer 2

Network
Video

COMPUTER 2cannotbeselectedwhenusingtheCOMPUTERIN2/
MONITOROUTterminalasMONITOROUToutput.