Sanyo PLC-WXU700 - Information; Input Source Information Display

63
Input Source Information Display
TheInformationMenuisusedforcheckingthestatusoftheimagesignalbeingprojectedandtheoperationoftheprojector.
H-sync freq.
V-sync freq.
Lamp counter
Information Menu
Thehorizontalfrequencyoftheinputsignalisdisplayedin
KHzor - - - - - whennosignal.
Theverticalfrequencyoftheinputsignalisdisplayedin
Hz
or- - - - - whennosignal.NumbersofHzdoubleswhen
duringInterlace.
Thecumulativelampoperatingtimeisdisplayed.
Direct Operation
PresstheINFO.buttonontheremotecontroltodisplaythe
InformationMenu.
INFO. button
Remote Control
PressthePoint▲▼buttonstoselectInformation.The
InformationMenuisdisplayed.
Seebelowfordisplayedinformation.
Menu Operation
Power management
Screen
Off,Ready,Shut downorTimer isdisplayed.
Theselectedscreensizeisdisplayed.
Input
Lamp status
Theselectedinputsourceisdisplayed.
Theselectedlampmodeisdisplayed.
Information
Language
Theselectedlanguageisdisplayed.
Key lock
TheselectedKeylockiconisdisplayed.
PIN code lock
Off,On 1orOn 2isdisplayed.
Remote control
Theselectedremotecodeisdisplayed.